Results of Research and Development
Heat Transfer Evaluation of Hybrid Mist Nozzles
Publication Year: 2012
RAUDENSKÝ, M. POHANKA, M. ONDROUŠKOVÁ, J. LUKS, T. STRÁNSKÝ, M.
Heat transfer of spray cooling using alumina/water nanofluids with full cone nozzles
Publication Year: 2012
BELLEROVÁ, H. TSENG, A. POHANKA, M. RAUDENSKÝ, M.
HTC Measurements for Secondary Cooling Nozzles
Publication Year: 2012
HORSKÝ, J. ONDROUŠKOVÁ, J. LUKS, T. CHABIČOVSKÝ, M.
Influence of the Rolling Loads on the Stress in the Roll Surface Layer
Publication Year: 2012
ZAHRADNÍK, R. HRABOVSKÝ, J. RAUDENSKÝ, M.
INFLUENCE OF THE WATER CHAMBER AND POSITION OF THE STABILIZER ON THE IMPACT PRESSURE AT HIGH PRESSURE DESCALING
Publication Year: 2012
HRABOVSKÝ, J. HORSKÝ, J.
INFLUENCE OF WATER TEMPERATURE ON HEAT TRANSFER COEFFICIENT IN SPRAY COOLING OF STEEL SURFACES
Publication Year: 2012
CHABIČOVSKÝ, M. RAUDENSKÝ, M. HNÍZDIL, M.
Influence of Water Temperature on the Cooling Intensity during Continuous Casting and Hot Rolling
Publication Year: 2012
HNÍZDIL, M. RAUDENSKÝ, M.
Influence of Water Temperature on The Cooling Intensity of Mist Nozzles in Continuous Casting
Publication Year: 2012
RAUDENSKÝ, M. HNÍZDIL, M. HWANG, J. LEE, S. KIM, S.
Low Cost Membrane Contactors Based on Hollow Fibres
Publication Year: 2012
RAUDENSKÝ, M. VESELÝ, T. DOHNAL, M.
Measurement of the existing sprayline cooling capacity and determining of upper limit of cooling intensity
Publication Year: 2012
RAUDENSKÝ, M. HORSKÝ, J. HNÍZDIL, M. CHABIČOVSKÝ, M. LUKS, T. KVAPIL, J. PELÍŠEK, M. HRAZDIL, V.
Mechanochemistry changes of the calcium carbonate grinding stock under the dry mode of the ultra-fine grinding conditions
Publication Year: 2012
SVĚRÁK, T. KEJÍK, P.
Showed 586–600 from 781 results