Detail publikace

Stress Intensity Factors for Cracks Emanating from a Notch under Shear-Mode Loading

HORNÍKOVÁ, J. ŠANDERA, P. ŽÁK, S. POKLUDA, J.

Anglický název

Stress Intensity Factors for Cracks Emanating from a Notch under Shear-Mode Loading

Typ

článek ve sborníku ve WoS nebo Scopus

Jazyk

en

Originální abstrakt

The influence of the notch geometry on the stress intensity factor at the front of the emanating cracks is well known for the opening loading mode. The critical length of the crack corresponding to a vanishing of the influence of the notch stress concentration can be approximately expressed by the formula aI,c = 0.5ρ(d/ρ)1/3, where d and ρ are the depth and radius of the notch, respectively. The aim of the paper was to find out if this formula could be, at least nearly, applicable also to the case of shear mode loading. The related numerical calculations for mode II and III loading were performed using the ANSYS code for various combinations of notch depths and crack lengths in a cylindrical specimen with a circumferential U-notch. The results revealed that, for mode II loading, the critical length was much higher than that predicted by the formula for mode I loading. On the other hand, the critical lengths for mode I and mode III were found to be nearly equal.

Anglický abstrakt

The influence of the notch geometry on the stress intensity factor at the front of the emanating cracks is well known for the opening loading mode. The critical length of the crack corresponding to a vanishing of the influence of the notch stress concentration can be approximately expressed by the formula aI,c = 0.5ρ(d/ρ)1/3, where d and ρ are the depth and radius of the notch, respectively. The aim of the paper was to find out if this formula could be, at least nearly, applicable also to the case of shear mode loading. The related numerical calculations for mode II and III loading were performed using the ANSYS code for various combinations of notch depths and crack lengths in a cylindrical specimen with a circumferential U-notch. The results revealed that, for mode II loading, the critical length was much higher than that predicted by the formula for mode I loading. On the other hand, the critical lengths for mode I and mode III were found to be nearly equal.

Klíčová slova anglicky

Critical Crack Length, Notch, Shear Modes, Stress Intensity Factor

Vydáno

01.08.2018

Nakladatel

Trans Tech Publications

ISBN

9783035713503

ISSN

1013-9826

Kniha

Key Engineering Materials: Advances in Fracture and Damage Mechanics XVII

Ročník

774

Strany od–do

48–53

Počet stran

6

BIBTEX


@inproceedings{BUT151736,
  author="Jana {Horníková} and Pavel {Šandera} and Stanislav {Žák} and Jaroslav {Pokluda},
  title="Stress Intensity Factors for Cracks Emanating from a Notch under Shear-Mode Loading",
  booktitle="Key Engineering Materials: Advances in Fracture and Damage Mechanics XVII",
  year="2018",
  volume="774",
  month="August",
  pages="48--53",
  publisher="Trans Tech Publications",
  isbn="9783035713503",
  issn="1013-9826"
}